Installing starter motor
- Feed in and install the starter motor (5).
- Tighten the screws (4).
TIGHTENING TORQUE SPECIFICATIONS
| Starter motor to crankcase | ||
|---|---|---|
| M8x60 | Tightening torque | 19 Nm |
- Insert the positive battery cable (3) and install it.
- Tighten the nut (2) hand-tight.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
CAUTION:
Improper routing of the positive battery cable
.
Risk of short circuits!
Risk of short circuits!
- Route the positive battery cable without abrasions and do not trap.
NOTE:
Schematic diagram is for example purposes. Some parts may differ in certain details.
- Attach the positive battery cable (1) correctly to antitwist lock (2).
- Tighten nut (3).
TIGHTENING TORQUE SPECIFICATIONS
| Battery positive lead to starter | ||
|---|---|---|
| M8 | Tightening torque | 15 Nm |
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .
- Refer to CONNECTING ALL BATTERY GROUND LEADS .