Installing the crankshaft sensor
- Feed in and install the crankshaft sensor (3).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Crankshaft sensor to crankcase | ||
|---|---|---|
| TS5x20 | tightening torque | 6 Nm |
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
Follow-up work
- Refer to INSTALLING THE STIFFENING PLATE .
- Refer to INSTALLING THE LEFT AND RIGHT FRONT UNDERSHIELD .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE FRONT SPOILER .