Remove the headlining (equipment specification with sliding/tilting sunroof)
Preliminary work
- Refer to REMOVING BOTH A-PILLAR TRIM PANELS .
- Refer to REMOVING BOTH SUN VISORS AND COUNTER SUPPORTS .
- Refer to REMOVING LEFT AND RIGHT HANDS-FREE MICROPHONE .
- Refer to OPEN SLIDING/TILTING SUNROOF .
- Refer to REMOVING THE ROOF FUNCTION CENTER (FZD) .
- Refer to REMOVING FRONT CEILING LIGHT .
- Refer to REMOVING REAR INTERIOR ROOF LIGHT .
- Refer to REMOVING ALL GRAB HANDLES .
- Refer to REMOVING THE BODY PILLAR TRIM PANELS OF THE TWO BODY PILLARS ON THE REAR LEFT AND RIGHT .
- Refer to DETACHING THE EDGE PROTECTION .
NOTE:
Perform the steps on the right and left side.
- Turn the coat hook to one side.
- Press the clamps together (arrows) and remove the coat hook.
- Remove the cover (1).
- Loosen the bolts (1) and remove the cover (2).
- Open sliding/tilting sunroof.
- Loosen screws (1).NOTE: RISK OF DAMAGE
Fold the headlining .
Damage to the headlining. If necessary, the headlining must be replaced .- Carry out tasks with a second person to assist.
- Support the headlining at the front and back.
- Loosen the expanding rivet (1).
- Loosen the expanding rivet (1).
- Unclip the headlining (3) from the clips (2).
- Adjust the backrest of the driver's and the front passenger seat all the way back.
- Detach the headlining (1) from the clips (2) downward in the marked areas.
- Pull the headlining (1) carefully to the back until the headlining (1) feeds out of the clip (2).
- Open all doors and all side windows.
- Remove the (1) headlining with the help of another person.
- Remove the clip (1) from the convertible top bow.