Installing the intake plenum

• Replace gaskets.

  Parts:  Seals

• Install the intake plenum.
• Fasten the tank ventilation line on the connecting element (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Secure the engine ventilation line to the connecting element (2).
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (2).
• Carefully clip the coolant expansion tank (1) into the holder on the intake plenum.

Courtesy of BMW OF NORTH AMERICA, INC.

• Attach the tank vent valve (1) to the holder (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE THROTTLE BODY .
• Refer to INSTALLING SERVICE CAP IN TRUNK .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to CONNECTING FRONT RIGHT BATTERY GROUND LEAD IN TRUNK .
• Refer to INSTALLING FRONT RIGHT COVER IN TRUNK .
• Refer to ACTIVATING HIGH-VOLTAGE SYSTEM .
• Refer to READING OUT THE FAULT MEMORY .