51 11 770 Remove and install/replace left or right deformation element for front bumper cover

Preliminary work needed: 

• Refer to REMOVING SUPPORT FOR TOPPING FRONT BUMPER COVER .

Unclip cable clip (1).

Remove screw (2).

Tightening torque 51 11 4AZ .

Loosen screws (3).

Tightening torque 51 11 7AZ .

Release screw (4).

Tightening torque 51 64 8AZ .

Pull out deformation element (5) towards front.

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note: 

CHECK attachment points (1) on side member (2).

Grind off any burr at attachment points (1).

Prime at bare metallic points and touch up with touch-up stick.

Courtesy of BMW OF NORTH AMERICA, INC.