Installing the rear brake disc

Courtesy of BMW OF NORTH AMERICA, INC.

• Thoroughly clean the contact surface of the wheel hub and remove traces of corrosion if necessary.

  Irregularities in the contact surface can cause distortion in the brake disc!

• Mount brake disk (2).
• Position and tighten the screw (1).
• Replace screw.

  Parts  : Screw

  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake disc to rear wheel hub
  M8 Replace screw.	Tightening torque	16 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

• Mount brake anchor plate.
• Insert screws (1) and tighten.
• Replace screws.

  Parts  : Screws

  TIGHTENING TORQUE SPECIFICATION
  
  

  Brake anchor plate to rear wheel carrier
  M12 Replace screw.	Tightening torque	130 Nm

Follow-up work 

• Refer to GREASING THE BRAKE PADS, THE BRAKE ANCHOR PLATE AND THE BRAKE CALIPER WITH BRAKE PAD PASTE .
• Refer to INSTALLING REAR BRAKE PADS .
• Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
• Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
• Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .