Installing rear brake pads

Courtesy of BMW OF NORTH AMERICA, INC.

• Install the brake pad (1) in arrow direction.

Courtesy of BMW OF NORTH AMERICA, INC.

• Remove the special tool (cable tie) 2 413 317. 
• Mount brake caliper (3).
• Replace screws (1).

  Parts  : Screws

• Tighten the screws (1), if applicable, hold against the hexagon head (2).
  TIGHTENING TORQUE SPECIFICATION
  
  

  Guide bolt (brake caliper on brake anchor plate)
  M8		tightening torque	35 Nm

Follow-up work 

• Refer to INSTALLING REAR BRAKE PAD WEAR SENSOR .
• Refer to INSTALLING REAR WHEEL ON THE LEFT AND RIGHT .
• Refer to START-UP OR BEDDING IN BREAK-IN OF NEW BRAKE PADS AND ROTORS (REAR BRAKE) .