Removing module bracket on the rear door
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Preliminary work
- Refer to REMOVING THE OUTER WINDOW CHANNEL STRIP AT THE REAR DOOR .
- Refer to REMOVING REAR DOOR TRIM .
- Secure the door window glass (1) when it is closed on top of the door frame with adhesive tape.
- Spread out the holder (2) using the special tool 0 496 569 (00 9 325) until the door window glass (1) can be detached.
- Simultaneously, operate the power window to shift it down approximately 10 cm and thereby detach the holder (2) from the door window glass (1).
- Loosen screws (1).
- Unclip door wiring harness (1) from module bracket (3) and unlock and disconnect the plug connections.
- Open locks (2) and remove module bracket (3).
Preliminary work
- Refer to REMOVING REAR DOOR TRIM .
- Loosen screws (1).
- Unclip door wiring harness (1) from module bracket (3) and unlock and disconnect the plug connections.
- Open locks (2) and remove module bracket (3).