Install the support for the bumper cover
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Install the support (3) for the bumper cover and tighten the nuts (2).
TIGHTENING TORQUE SPECIFICATIONS
| Rear bumper support to body | ||
|---|---|---|
| Nut | Tightening torque | 108 Nm |
- Tighten nuts (1).
TIGHTENING TORQUE SPECIFICATIONS
| Rear silencer to bumper bracket | ||
|---|---|---|
| M8 | tightening torque | 19 Nm |
- Install the adapter (3) and mount the expanding rivets (2).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bumper panel, rear | ||
|---|---|---|
| Hexagon screw | Tightening torque | 3.0 Nm |
Follow-up work
- Refer to INSTALL REAR BUMPER PANEL .
- Refer to INSTALLING REAR REFLECTOR .
- Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALL THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .