Installing the rear door sill cover strip (electrical rear seat)

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: RISK OF DAMAGE
Bending of plastic components .
Application of too much force can lead to bending of plastic components .

Place special tool directly beside the mounting clip.
Continue unclipping the part without using the tool if possible.

NOTE: Description is for left component only. Procedure on the right side is identical.

Check the snap-in lugs (1) for damage.
The snap-in lugs (1) must not be damaged or missing.

Courtesy of BMW OF NORTH AMERICA, INC.
Position the rear door sill cover strip (2) on the body.
Engage the rear door sill cover strip (2) on the detents (3).
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Door sill cover strip to body
Screw 4.8x16	Tightening torque	1.4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the illuminated sill trim on the rear door sill

NOTE: RISK OF DAMAGE
Bending of plastic components .
Application of too much force can lead to bending of plastic components .

Place special tool directly beside the mounting clip.
Continue unclipping the part without using the tool if possible.

NOTE: Description is for left component only. Procedure on the right side is identical.

Version A:
Check the detents (2) for damage, if necessary replace the illuminated sill trim (1).

Mount the illuminated sill trim (1) and connect and lock the connector while doing so.

Position the illuminated sill trim (1) and lock on the detentes (2).

Courtesy of BMW OF NORTH AMERICA, INC.
Version B:
Check the detents (2) for damage, if necessary replace the illuminated sill trim (1).

Mount the illuminated sill trim (1) and connect and lock the connector while doing so.

Position the illuminated sill trim (1) and lock on the detentes (2).

Courtesy of BMW OF NORTH AMERICA, INC.