Tightening the VANOS central valve of the intake adjuster

WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.

Have the special tool 0 496 855 ready.

Courtesy of BMW OF NORTH AMERICA, INC.
Have the special tool 2 450 487 ready.

Courtesy of BMW OF NORTH AMERICA, INC.
Have the special tool 2 469 138 ready.

Courtesy of BMW OF NORTH AMERICA, INC.
Keep a standard torque wrench (1) ready.

Courtesy of BMW OF NORTH AMERICA, INC.

Lay out all special tools and standard tools.

Number	Description
1	Standard torque wrench
2	Wrench socket set 2 450 487
3	Reversible ratchet 0 496 855
4	Standard reduction
5	Adapter 2 469 138

Courtesy of BMW OF NORTH AMERICA, INC.

Assemble all special tools and standard tools as shown.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: The figure shows the rear of the engine.
Tighten the VANOS central valve (1) of the intake adjuster.

Courtesy of BMW OF NORTH AMERICA, INC.

TIGHTENING TORQUE SPECIFICATIONS

VANOS central valve to camshaft
M21 VANOS central valve on the thread and on the contact surface must be coated with engine oil.	1. Joining torque	50 Nm
	2. tightening torque	140 Nm
M22 VANOS central valve on the thread and on the contact surface must be coated with engine oil.	1. Joining torque	50 Nm
	2. tightening torque	140 Nm

Follow-up work

Refer to DISASSEMBLING ALL SPECIAL TOOLS .
Refer to INSTALL CHAIN TENSIONER .
Refer to CHECKING THE TIMINGS OF THE CAMSHAFT .
Refer to INSTALLING THE HOLDER OF THE POSITIVE BATTERY CABLE .
Refer to INSTALLING THE CENTER STRUT BRACE MOUNT .
Refer to INSTALLING THE LOWER SECTION OF THE FRONT WALL .