Replace intake plenum
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
RISK OF DAMAGE
Electrostatic discharge .
Damage to or destruction of electrical components .
Electrostatic discharge .
Damage to or destruction of electrical components .
- Leave the electrical components in their original packaging until they are being installed. Only use the original packaging for returning the product. Always package removed components straight away.
- Read and comply with user information on using the associated special tool 12 7 060.
- Only tap the housings of electrical components. Do not tap pins or multi-pin connectors directly.
- Wear electrically conductive clothing and antistatic shoes (with ESD symbol).
- For additional information see: NOTES ON ESD PROTECTION (ELECTRO STATIC DISCHARGE) .
- Loosen clamp (1).
- Loosen screw (2).
- Remove the boost pressure sensor (3).
- Feed out the rubber grommet (1) and remove it.
- Loosen clamp (2).
- Loosen clamp (1).
- Remove the screws (arrowed).
- Remove the throttle bodies (1).
- Replace the sealing ring (1) with the special tool 0 496 714 (00 9 030)
.
Parts: Sealing ring
- Feed in and install the throttle body (1).
- Tighten the screws (arrowed).
TIGHTENING TORQUE SPECIFICATIONS
| Throttle body to intake plenum | |
|---|---|
| M6x50 | Tightening torque 7 Nm |
- Check the sealing ring (1) for damage, replace it if necessary.
Parts: Sealing ring
- Apply a thin coat of lubricant to the sealing ring (1) of the boost pressure sensor.
- Insert and install the boost pressure sensor (3).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Boost pressure sensor to intake plenum | |
|---|---|
| TS6x20 | Tightening torque 5 Nm |