Installing the fog light bracket on the left and right
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
Installing fog light support
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Correctly position the fog light bracket (3) and engage at detents (arrows).
- Tighten down screw (2).
TIGHTENING TORQUE SPECIFICATIONS
| Front fog lamp holder to bumper panel | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
- Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .
- Position holder (2).
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Front fog lamp holder to bumper panel | ||
|---|---|---|
| screw | Tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALL BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALL FRONT ORNAMENTAL GRILLE .
- Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE FRONT LICENSE PLATE .