Install the integrated power supply module (PDM)

Insert and install the integrated power supply module (PDM) (2).
The lock (1) must audibly engage.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: TECHNICAL INFORMATION
The number of connectors on the described component may vary depending on the equipment version.
If necessary, unlock and disconnect, or connect and lock, all other connectors.

Connect connectors (1) and lock.
The connectors (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect connectors (1) and lock.
The connectors (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE ENGINE CONTROL UNIT COVER .
Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .
Refer to DISCONNECTING ALL BATTERY GROUND LEADS .