Install tension strut on shock tower
NOTE:
TECHNICAL INFORMATION
Driving without the strut brace/front-end strut or tension strut is not permitted.
Driving without the strut brace/front-end strut or tension strut is not permitted.
- (3) Install tension strut on shock tower.
- Replace the screw (1).
Parts: Screw
- Tighten screw (1) with the special tool 0 490 504 (00 9 120)
.TIGHTENING TORQUE SPECIFICATIONS
Tension strut to shock tower M10x55 screw Replace screws Joining torque 56 Nm Angle of rotation 90° - Tighten down screw (2).TIGHTENING TORQUE SPECIFICATIONS
Tension strut on the rear cross connection M8x30 screw tightening torque 28 Nm Repairing the thread on the strut tower
- Repair the damaged thread with the Helicoil thread insert.CONSUMABLE SPECIFICATION
Helicoil thread Insert M10x25 mm 33 30 6 782 756