Installing the right high-pressure rail

• Loosen screws (1).
• Slacken hold-down device (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: TECHNICAL INFORMATION 
  Always install the high pressure line or rail free of distortion. To ensure distortion-free installation of the high pressure line and to avoid damaging the thread, it must be possible for both nuts to be screwed on to the injectors easily hand force.
• First insert the rail (2) at the high pressure pump connector, then lower it to the point where the ball heads are positioned inside the injector connections and the rail is correctly positioned.

  Courtesy of BMW OF NORTH AMERICA, INC.

• Then tighten the nuts (1) on the injectors so they are hand-tight.
• Next, hand-tighten the nut (3) of the high pressure pump.
• Lastly, mount screws (4) and hand-tighten.
• Tighten down screws (4).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rail to cylinder head cover
  M6x25 screw	Tightening torque	10 Nm

  NOTE: The description is for one component only. The procedure is identical for all further components.
• Tighten down screws (1).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Hold-down device to cylinder head cover
  screw	Tightening torque	13 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten nuts (1) on the injectors with the special tool 0 495 908 (37 1 150).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  High-pressure rail to injectors
  Nuts	Tightening torque	23 Nm

• Tighten nut (3) on the high pressure pump with the special tool 0 491 277 (13 5 020) .

  Courtesy of BMW OF NORTH AMERICA, INC.

  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Fuel supply line/rail to high pressure pump
  Nut	tightening torque	30 Nm

• Tighten down screws (4).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rail to cylinder head cover
  M6x25 screw	Tightening torque	10 Nm

• Connect plug connection (1) and lock.

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE SOUND INSULATION OF THE INJECTORS, RIGHT .
• Refer to INSTALLING IGNITION COILS FROM CYLINDER BANK 1 .
• Refer to INSTALLING THE RIGHT INTAKE SILENCER BRACKET .
• Refer to INSTALLING THE RIGHT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .