Installing the support for the front bumper cover at the bottom
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
- Thread in the support for the bumper cover (2).
- Position all screws and center the support for the bumper cover (2).
NOTE:
Perform the steps on the right and left side.
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Bottom support on front axle support adapter | ||
|---|---|---|
| M8x70 screw | Tightening torque | 19 Nm |
NOTE:
Perform the steps on the right and left side.
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Vertical connection to support for bumper cover | ||
|---|---|---|
| M6x20 screw | Tightening torque | 11.8 Nm |
Follow-up work
- Refer to INSTALLING THE LOWER LEFT FRONT WHEEL ARCH COVER .
- Refer to INSTALL LEFT AND RIGHT BRAKE VENTILATION DUCT .
- Refer to INSTALL BUMPER COVER, FRONT .
- Refer to PARTIALLY INSTALLING THE FRONT SECTION OF THE FRONT WHEEL ARCH COVER ON THE LEFT AND RIGHT .
- Refer to PARTIALLY INSTALLING THE LEFT FRONT AND RIGHT WHEEL ARCH TRIM .
- Refer to INSTALL FRONT ORNAMENTAL GRILLE .