Securing left and right spring strut holders on the lower wishbone
WARNING: This page is about a different car, the 2023 BMW X5, 2022 BMW X5, 2021 BMW X5, 2020 BMW X5, and 2019 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Perform the steps on the right and left side.
Fasten the spring strut holder on the bottom wishbone
NOTE:
TECHNICAL INFORMATION
Tighten the screw connection in the NORMAL POSITION .
Tighten the screw connection in the NORMAL POSITION .
- Position spring strut holder on the bottom wishbone.
- Replace screw (3) and the nut (1).
Parts: Bolt and nut
- Punch in the swivel bearing (2) at the front towards the inner.
- Insert screw (3).
- Tighten the nut (1) in NORMAL POSITION .
TIGHTENING TORQUE SPECIFICATIONS
| Spring strut holder to lower wishbone | ||
| M14 Replace screw and nut. Tighten the screw connection in the normal position! |
Joining torque Angle of rotation |
165 Nm 90° |