Install the rear blower

• Feed the rear blower (2)  into the center console (3)  and install.
  NOTE: Fasten the adjacent threaded plate for the screws (1) in the center console (3) from the top.
• Tighten down screws (1)  .
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  Rear blower to center console
  screw
  	Tightening torque	1.5 Nm

  Courtesy of VOLVO CARS CORPORATION

• Correctly route the cable (2)  and engage with the cable brackets (3)  .
• Connect the connector (1)  for the rear blower and lock.

  Courtesy of VOLVO CARS CORPORATION

• Connect plug (1)  .
• Position the interior antenna (2)  correctly and slide in the direction of the arrow until the detent (3)  engages.

  Courtesy of VOLVO CARS CORPORATION

• Feed in the air duct (1)  on the guides (3)  from the top.
• Correctly slide the air ducts (1)  at bottom onto the rear blower (2)  .

  Courtesy of VOLVO CARS CORPORATION

• Route the cable (1)  correctly.
• Engage the cable bracket (2)  .

  Courtesy of VOLVO CARS CORPORATION

Follow-up work 

• Refer to INSTALLING THE FRONT STORAGE COMPARTMENT .
• Refer to INSTALLING THERMOELECTRIC COOLING AND HEATING SYSTEM FOR A CUP HOLDER .
• Refer to INSTALLING THE CENTER CONSOLE .
• Refer to INSTALLING THE CUP HOLDER .
• Refer to INSTALLING THE CENTER ARMREST .
• Refer to INSTALLING THE CENTER CONSOLE TRIM .
• Refer to INSTALLING THE CENTER ARMREST STORAGE COMPARTMENT .
• Refer to INSTALLING THE CARPET ON THE CENTER CONSOLE AT LEFT AND RIGHT SIDES .
• Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
• Refer to DISCONNECTING ALL BATTERY GROUND LEADS .
• Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .