Installing the side member of the luggage compartment trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the side member of the luggage compartment trim panel (3).
- Tighten the screws (1).TIGHTENING TORQUES SPECIFICATION
Side member trim panel to side member Screw tightening torque 3 Nm - Tighten nut (2).TIGHTENING TORQUES SPECIFICATION
Side member trim panel to side member Nut tightening torque 3 Nm - Install the foam part (1).
Follow-up work
- Refer to INSTALLING LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL .
- Refer to INSTALLING THE FLAP IN THE LEFT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING D-PILLAR TRIM PANEL .
- Refer to INSTALLING COVER OF THE SEAT BELT FINISHER STRIP .
- Refer to INSTALLING LOADING EDGE TRIM .
- Refer to INSTALLING THE BATTERY COVER .
- Refer to INSTALLING COVER FOR THE SIDE MEMBER .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING THE STORAGE SHELF .