Remove left tank vent valve
NOTE:
RISK OF DAMAGE
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
Careless handling of tools and sharp-edged components.
Scratches, surface damage.
- Protect working area.
- Handle tools and components carefully.
NOTE:
TECHNICAL INFORMATION
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can take up to 11 minutes. This protects the components. In this case, replacing the electric fan is not necessary.
When the engine is stopped after the completion of trip, it may be necessary to run the electric fan. In rare cases, operation of the electric fan can take up to 11 minutes. This protects the components. In this case, replacing the electric fan is not necessary.
Preliminary work
- Refer to REMOVING THE TOP RIGHT AND LEFT COVER IN THE ENGINE COMPARTMENT .
- Refer to REMOVING UPPER CROSS CONNECTION .
- Refer to REMOVING THE TENSION STRUT AT THE SHOCK TOWER ON THE LEFT AND RIGHT .
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING BOTH INTAKE FILTER HOUSINGS .
- Refer to REMOVING THE UNFILTERED-AIR DUCT ON THE RIGHT AND LEFT .
- Refer to REMOVING THE REAR TOP CROSS CONNECTION .
- Refer to REMOVING THE FAN COWL .
- Release the belt tensioner (2) clockwise in the direction of the arrow using a suitable socket wrench (1).
- Maintain the preload of the belt tensioner (1) using a suitable socket wrench (3).
- Secure the belt tensioner (1) against turning with the special tool 0 496 268 (11 0 390) (2).
- Remove the drive belt from the air conditioning compressor.
- Unlock and disconnect the tank vent line (1) below the left throttle body.
- Unlock plug connection (1) and disconnect.
- Unlock and disconnect the tank vent line (3).
- Feed out and remove the tank vent valve (2) from the bracket.