Install the front top cross connection

• Attach the front top cross connection (2).
• Tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Top front cross connection to hood lock support
  screw	Tightening torque	19 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

  NOTE: Perform the steps on the right and left side.
• Carefully feed in the holder (2) and tighten the screws (1).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Holder on headlight
  screw	Tightening torque	1.9 Nm

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten screws (2).
  TIGHTENING TORQUES SPECIFICATION
  
  

  Front reinforcement strut
  screw	Tightening torque	24 Nm

• Mount the expanding rivets (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSERTING TOP AUTOMATIC AIR FLAP CONTROL .
• Refer to INSTALLING UPPER CROSS CONNECTION .
• Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .
• Refer to INSTALLING THE FRONT HOOD SEAL .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to INSTALLING THE FRONT PART OF THE LEFT FRONT AND RIGHT WHEEL ARCH COVER (PARTIALLY REMOVED) .
• Refer to INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM (PARTIALLY REMOVED) .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
• Refer to PUTTING THE FRONT RADAR SENSORS INTO OPERATION .