Installing/replacing the right rail pressure sensor

Precondition 

High-pressure rail is removed.

• Replace the rail pressure sensor (2)  .

  Parts:  Rail pressure sensor

• Screw in the rail pressure sensor (2)  in the high-pressure rail and tighten it.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Rail pressure sensor to rail
  Rail pressure sensor M10	Tightening torque	35 Nm

• Unclamp the rail on the lug (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING RAIL OF CYLINDER BANK 1 .
• Refer to INSTALLING IGNITION COILS OF CYLINDER BANK 1 .
• Refer to INSTALLING BRACKET FOR RIGHT INTAKE SILENCER .
• Refer to INSTALLING RIGHT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .