Install/replace the left rail pressure sensor

Precondition 

High-pressure rail is removed.

• Replace the rail pressure sensor (2)  .

  Parts:  Rail pressure sensor

• Screw in the rail pressure sensor (2)  in the high-pressure rail and tighten it.
  TIGHTENING TORQUE SPECIFICATION
  
  

  Rail pressure sensor to rail
  Rail pressure sensor M10	Tightening torque	35 Nm

• Unclamp the rail on the lug (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING RAIL ON BANK 2 .
• Refer to INSTALLING THE IGNITION COILS OF CYLINDER BANK 2 .
• Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
• Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
• Refer to INSTALLING ACOUSTIC COVER .
• Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .