Installing the vibration damper
- Clean the contact surface of the central bolt (7).
- Align and position vibration damper for the Woodruff key of the sprocket wheel.
- Position shim (4).
- Position fitting sleeve (2).
The notches (6) of the fitting sleeve (2) must point to the counter support (5).
- Position counter support (5).
- Tighten the screws (1) and (3) hand-tight.
- Replace central bolt (2).
Parts: Central bolt
- Treat the contact surface (1) of the central bolt (2) with lubricating grease.CONSUMABLE SPECIFICATIONS
Lubricating grease SYNTHESO GLEP1 100 g, Tube 83239407778 - Tighten central bolt (7).TIGHTENING TORQUE SPECIFICATIONS
Central bolt Screw M 18x1.5x122 Replace screw.
Replace screws grease screw head see Consumables 4.8Joining torque 100 Nm 1. Angle of rotation
60°2. Angle of rotation
60°3. Angle of rotation
60° - Release the counter support (5) and shim (4) with the screws (1).
- Release the fitting sleeve (2) and counter support (5) with the screw (3).
- Remove the counter support (5) from the vibration damper.
- Remove the fitting sleeve (2).
Follow-up work
- Refer to INSTALLING THE BELT PULLEY ON THE TORSIONAL VIBRATION DAMPER .
- Refer to INSTALLING THE BELT TENSIONER .
- Refer to INSTALLING DRIVE BELT .
- Refer to INSTALLING THE COOLANT EXPANSION TANK FOR THE LOW-TEMPERATURE COOLANT CIRCUIT .
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE RIGHT STRUT BRACE .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT , and INSTALLING THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .