Installing the speaker cover from the door trim panel
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Saw off all welding pins on the speaker cover (1) along the molding (2).
- Remove welding remnants on door trim panel with a scalpel.
- Install the speaker cover (1) and lock on the detents (2).
Welding pins must not protrude from the door trim panel.
- Screw in and tighten the repair screws (arrows).
TIGHTENING TORQUE SPECIFICATIONS
| Decorative strip/speaker trim to door trim panel | ||
|---|---|---|
| screw | Tightening torque | 1.8 Nm |
Follow-up work
- Refer to INSTALLING THE DECORATIVE STRIP ON THE DOOR TRIM PANEL .
- Refer to INSTALLING REAR DOOR TRIM PANEL .