Install exhaust cover
- Insert the exhaust cover (2) on the holder and engage at detent (3).
- Replace screws (1).
Parts: Screw
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Exhaust cover on holder | ||
|---|---|---|
| Screw Replace screw |
tightening torque | 3 Nm |
- Install the bracket (2) together with the exhaust cover.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Exhaust cover holder to bumper panel | ||
|---|---|---|
| Screw | tightening torque | 3 Nm |
- Mount blind rivet (2) using the special tool 0 496 521 (00 2 230) .
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Exhaust cover holder to bumper panel | ||
|---|---|---|
| Screw | tightening torque | 3 Nm |
Follow-up work
- Refer to INSTALL REAR BUMPER PANEL .
- Refer to INSTALLING REAR REFLECTOR .
- Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALL THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .