Install right luggage compartment wheel arch trim panel (all equipment versions)
NOTE:
Description is for left component only. Procedure on the right side is identical.
Installing the luggage compartment wheel arch trim panel on left (all equipment versions)
Installing left luggage compartment wheel arch trim panel (without 3rd row seats)
- Release the cover (1) from the rear at the detents (2) and remove it.
- Version A:
- Feed in the luggage compartment wheel arch trim panel (2) at the trunk lid lock. Hook the Bowden cable (1) in on the luggage compartment wheel arch trim panel (2).
- Connect and lock the present connectors.
- Version B:
- Feed in the luggage compartment wheel arch trim panel (2) at the trunk lid lock. Hook the Bowden cable (1) in on the luggage compartment wheel arch trim panel (2).
- Connect and lock the present connectors.
- Correctly position the luggage compartment wheel arch trim panel (3).
- Make sure the luggage compartment wheel arch trim panel (3) is seated correctly on the tailgate seal.
- Clip in the luggage compartment wheel arch trim panel (3) at the clip in the upper area.
- Install the expanding rivet (1).
- Tighten the screw and mount the cover (2).
TIGHTENING TORQUE SPECIFICATIONS
| Luggage compartment wheel arch trim panel on body | ||
|---|---|---|
| screw | Tightening torque | 3.0 Nm |
- Variant without electrical roller cover for luggage compartment:
Install the expanding rivet (1).
- Check whether the detents (1) and guides (2) are present and have damage; if necessary replace the cover.
- Install and lock the cover (1).
Installing the left luggage compartment wheel arch trim panel (with 3rd row of seats)
- Release the covering (1) from behind at the detents (2) and remove.
- Feed in the luggage compartment wheel arch trim panel (2) at the trunk lid lock.
- Connect connectors (1) and lock.
- Position the luggage compartment wheel arch trim panel (3) correctly and clip in at the clips (4).
- Tighten the screw and install the cover (2).
TIGHTENING TORQUE SPECIFICATIONS
| Luggage compartment wheel arch trim panel on body | ||
|---|---|---|
| screw | Tightening torque | 3.0 Nm |
- Tighten down screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Luggage compartment wheel arch trim panel on body | ||
|---|---|---|
| screw | Tightening torque | 3.0 Nm |
- Replace the screw (1).
Parts: Screw
- Install the seat belt end fitting and tighten the screw (1).
TIGHTENING TORQUE SPECIFICATIONS
| Strap fitting on the lower body | ||
|---|---|---|
| Screw Replace screw |
Tightening torque | 42 Nm |
- Feed in and install the covers (1).
- Check whether the detents (1) and guides (2) are present and have damage; if necessary replace the cover.
- Install and lock the cover (1).
Follow-up work
- Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to INSTALL THE REAR DOOR SILL COVER STRIP .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALL LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .