Installing the bumper cover
- Correctly position the side section of the bumper cover (2) and engage on the detents (arrows).
- Mount blind rivet (1) using the special tool 0 496 521 (00 2 230) .
Follow-up work
- Refer to INSTALLING THE SUPPORTS FOR THE EXHAUST COVERS LEFT AND RIGHT .
- Refer to INSTALL REAR BUMPER PANEL .
- Refer to INSTALLING REAR REFLECTOR .
- Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
- Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALL THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
- Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
- Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE TRIM ON THE LOWER BUMPER COVER .