Install the right tank vent valve
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Thread in and install the tank vent valve (2) on the bracket.
- Connect and lock tank vent line (3).
The tank vent line (3) must engage audibly.
- Connect connectors (1) and lock.
The connector (1) must engage audibly.
- Connect the tank vent line (1) below the throttle body to the right intake plenum and lock it.
The tank vent line (1) must engage audibly.
Follow-up work
- Refer to INSTALLING FAN COWL .
- Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
- Refer to INSTALLING THE RIGHT AND LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING BOTH INTAKE FILTER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING UPPER CROSS CONNECTION .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .