Install heat shield, top
WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.
- Install top heat shield (2).
- Tighten down screws (1).
TIGHTENING TORQUES SPECIFICATION
| Heat protection plate | ||
|---|---|---|
| M6x16 | tightening torque | 10 Nm |
Install the engine ventilation line of cylinders 5 to 8
- Position and guide in the engine ventilation line (3) towards the front.
- Position the intake pipe (2).
- Connect and lock intake pipe (2) and engine ventilation line (3).
- The retaining clips (1) must audibly engage.
- Position the engine ventilation line.
- Tighten the screws (2).
TIGHTENING TORQUES SPECIFICATION
| Engine ventilation line | ||
|---|---|---|
| screw | Tightening torque | 9.3 Nm |
Follow-up work
- Refer to INSTALLING THE LEFT INTAKE SILENCER BRACKET .
- Refer to INSTALLING THE LEFT LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING THE RIGHT LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING THE RIGHT INTAKE SILENCER HOUSING .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING ACOUSTIC COVER .