Install left tank vent valve

WARNING: This page is about a different car, the 2022 BMW X7, 2021 BMW X7, 2020 BMW X7, and 2019 BMW X7. However, it is still accessible from the selected car via links, so may be relevant.

Guide the tank vent valve (2) in to the mount and install.
Connect and lock tank vent line (3).
The tank vent line (3) must engage audibly.
Connect connectors (1) and lock.
The connector (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.
Connect tank vent line (1) to the left intake plenum under the throttle body and lock.
The tank vent line (1) must engage audibly.

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: For a better overview the removed condition is shown here.
Fit drive belt (1) on the air conditioning compressor.
Check that the drive belt (1) is seated correctly.

Courtesy of BMW OF NORTH AMERICA, INC.
Maintain the preload of the belt tensioner (1) using a suitable socket wrench (3).
Remove the special tool 0 496 268 (11 0 390) (2) from the belt tensioner.

Courtesy of BMW OF NORTH AMERICA, INC.
Loosen the belt tensioner (2) counterclockwise using a suitable socket wrench (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING FAN COWL .
Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
Refer to INSTALLING INTAKE FILTER HOUSING .
Refer to INSTALLING THE RIGHT STRUT BRACE .
Refer to INSTALLING THE STRUT BRACE .
Refer to INSTALLING ACOUSTIC COVER .
Refer to INSTALLING THE REAR TOP CROSS CONNECTION .
Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
Refer to INSTALLING UPPER CROSS CONNECTION .
Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT AND RIGHT .