Install the VDP control unit

• Position the VDP control unit (2).
• Tighten the nuts (arrows).
  TIGHTENING TORQUE SPECIFICATIONS
  
  

  VDP control unit to body
  M6	Tightening torque	6 Nm

• Connect and lock all connectors (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING THE LUGGAGE COMPARTMENT TRIM PANEL ON THE RIGHT .
• Refer to INSTALLING THE RIGHT D-PILLAR TRIM PANEL .
• Refer to INSTALLING THE RIGHT C-PILLAR TRIM PANEL .
• Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
• Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL .
• Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
• Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
• Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING FLAP IN RIGHT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to CONNECTING ALL BATTERY GROUND LEADS .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
• Refer to PROGRAM/ENCODE THE VDP CONTROL UNIT .
• Refer to CARRYING OUT RIDE HEIGHT ADJUSTMENT .