Install rear bumper panel

• Install the bumper cover (3).

  Guide in bumper cover (3) and thereby connect and lock all plugs.

• Insert bumper cover (3) in the guides (2) and engage on the snap-in lugs (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Lock in bumper cover in the area of the side panel on the detents.
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Only for G07: 
• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Check the clip (2), it must not damaged or missing.

  Clip,  (2) always install with the sealing ring  .

• Check detents (3), they must not be damaged or missing.
• Clip in the wheel arch trim (1) with the clip (2).
• Engage the wheel arch trim (1) into the detents (3) in the area of the bumper cover.

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screw (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

• Loosen screws (1).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING REAR REFLECTOR .
• Refer to INSTALLING TAIL LIGHT ON LEFT AND RIGHT SIDE PANEL .
• Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
• Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
• Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
• Refer to INSTALL THE FLAP IN LEFT LUGGAGE COMPARTMENT TRIM PANEL .
• Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
• Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .
• Refer to INSTALLING THE RIGHT BOTTOM C-PILLAR TRIM PANEL (3RD ROW OF SEATS) .
• Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
• Refer to INSTALLING RIGHT BACKREST SIDE SECTION .