Installing the left front carpet
- Lay removed carpet on the new carpet (1) and transfer cuts to new carpet (1).
- Cut off the highlighted area (2) on the new carpet (1).
- Insert the carpet (1) in the car.
- Make sure the carpet (1) is positioned correctly at all adjacent parts and in area of heating and air conditioning unit.
- Install the holder (2) and tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Center console holder at the center on body | ||
|---|---|---|
| Hexagon screw | tightening torque | 4.6 Nm |
Follow-up work
- Refer to INSTALLING THE SPEAKER TRIM ON THE CENTER BASS .
- Refer to INSTALLING THE AIRBAG CONTROL UNIT .
- Refer to INSTALLING ACCELERATOR PEDAL MODULE .
- Refer to INSTALLING THE SIDE TRIM PANEL IN THE FOOTWELL AT THE LEFT A-PILLAR .
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
- Refer to INSTALLING THE FRONT DOOR SILL COVER STRIP .
- Refer to INSTALLING THE CENTER CONSOLE .
- Refer to PARTIALLY INSTALLING STORAGE COMPARTMENT OF CENTER ARMREST .
- Refer to INSTALLING THE CARPET ON THE CENTER CONSOLE AT LEFT AND RIGHT SIDES .
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to INSTALLING FRONT SEAT .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .