Installing tail light onto side panel at right
NOTE:
Description is for left component only. Procedure on the right side is identical.
Install the tail light on the side panel
- Check seal (1) on the rear light (2) for damage and replace if necessary.
Check
NOTE:
TECHNICAL INFORMATION
The thread is a left-hand thread.
The thread is a left-hand thread.
- Both adjusting elements (1) on the rear light (2) must be in the screwed in position.
Result
» Adjusting elements (1) are not in the screwed in position.
Measure
- Screw in adjusting elements (1) counterclockwise.
- Connect the connector (1) to the tail light (2).
The connector must engage audibly.
- Lock the lock (3) in direction of arrow.
- Position rear light (1) on the side panel (2).
- Fold up the sound insulation (1) and start threading the underlying nut.
- Position rear light (1) to the front (arrow).
- Move the contact surfaces (2) of the rear light (1) upwards (arrow) to contact.
- Hold rear light (1) in position.
- Fold up the sound insulation (1) and tighten the underlying nut.TIGHTENING TORQUE SPECIFICATIONS
Tail light to side panel Nut tightening torque 3 Nm - Align the rear light (1) to the connection line (2).
- Tighten down screws (3).TIGHTENING TORQUE SPECIFICATIONS
Tail light to side panel Screw tightening torque 3.6 Nm - Position the cover panel of the water channel (1) and clip in arrow direction.
Follow-up work
- Refer to INSTALLING RIGHT LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL (ALL EQUIPMENT VERSIONS) .
- Refer to INSTALLING THE BOTTOM LEFT C-PILLAR TRIM PANEL (3RD SEAT ROW) .
- Refer to INSTALLING THE REAR DOOR SILL COVER STRIP (ELECTRICAL REAR SEAT) .
- Refer to INSTALLING RIGHT BACKREST SIDE SECTION .
- Refer to INSTALLING THE LEFT OR RIGHT LUGGAGE COMPARTMENT LAMP .
- Refer to INSTALLING THE FLAP IN THE LUGGAGE COMPARTMENT WHEEL ARCH TRIM PANEL ON THE RIGHT .
- Refer to INSTALLING LUGGAGE COMPARTMENT FLOOR COVERING .
- Refer to INSTALLING ROLLER COVER FOR LUGGAGE COMPARTMENT .