Install front intake pipe
- Insert intake pipe (1) completely from top to bottom and install.
- Position intake pipe (1)
correctly.
- Tighten screw (1)
of the intake pipe (2)
.TIGHTENING TORQUE SPECIFICATIONS
Refrigerant line to connecting piece M8 Tightening torque 19 Nm - Insert intake pipe (2) below the lines (3) and insert in the holder (1) .
- Engage holder (1)
.
- Place the intake pipe (2) on the air conditioning compressor (3) .
- Tighten the screw (1)
from the side of the wheel well on the intake pipe (2)
.TIGHTENING TORQUE SPECIFICATIONS
Refrigerant line on air conditioning compressor M8 tightening torque 19 Nm
Follow-up work
- Refer to INSTALLING THE COVER OF THE STEERING ASSEMBLY .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .
- Refer to INSTALLING THE LEFT UNFILTERED-AIR DUCT .
- Refer to INSTALLING LEFT INTAKE SILENCER HOUSING .
- Refer to INSTALLING THE HOLDER FOR THE DME CONTROL UNIT ON THE LEFT .
- Refer to INSTALLING THE DME CONTROL UNIT OF CYLINDERS 5 TO 8 .
- Refer to INSTALLING COVER FOR THE LEFT DME CONTROL UNIT .
- Refer to INSTALLING THE FRONT-END STRUT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to INSTALLING THE COVER IN THE ENGINE COMPARTMENT AT TOP LEFT and INSTALL THE COVER IN THE ENGINE COMPARTMENT ON THE TOP RIGHT .
- Refer to RECONNECTING ALL BATTERY GROUND LEADS .
- Refer to EVACUATE AND CHARGE CONDITIONING .