Install control unit bracket
- Make sure the control unit bracket (1) at bottom is fed into the mount (2) correctly.
- Insert and install the control unit holder (2) in the direction of the arrow.
- Tighten down screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Control unit bracket at the shock tower | ||
| Hexagon screw | tightening torque | 8 Nm |
- Mount the cable bracket (1) together with the wiring harnesses and lock it audibly.
- Secure the wiring harness in holder (1).
- Secure the holder (1) audibly.
- Secure the cable with the clamp (2) on the control unit holder.
- Pin up connector (3) and lock audibly.
- Secure the connector (3) on the control unit holder.
Follow-up work
- Refer to INSTALLING THE INTEGRATED POWER SUPPLY MODULE (PDM) .
- Refer to INSTALLING THE DME CONTROL UNIT .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to ACTIVATING ELECTRICAL SYSTEM .