Installing the coolant feed line for the turbocharger
- Replace O-rings (1)
on the coolant feed line with the special tool 0 496 714 (00 9 030)
.
Parts: O-rings
- Guide in coolant feed line (2) on the crankcase and install.
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Coolant feed line to crankcase | ||
| M6 x 12 | Tightening torque | 8 Nm |
- Guide in coolant feed line (2) on the turbocharger and install.
- Tighten down screw (1) .
TIGHTENING TORQUES SPECIFICATION
| Coolant feed line/coolant return line to turbocharger | ||
| M6 x 12 | Tightening torque | 8 Nm |
Follow-up work
- Refer to INSTALLING CATALYTIC CONVERTER .
- Refer to INSTALLING EXHAUST SYSTEM .
- Refer to INSTALLING THE CONNECTING SUPPORTS ON THE TUNNEL .
- Refer to INSTALLING TANK COVER ON LEFT AND RIGHT .
- Refer to INSTALLING LAMBDA OXYGEN SENSOR .
- Refer to INSTALLING ACOUSTIC COVER AT REAR .
- Refer to INSTALLING THE COWL UPPER PART .
- Refer to INSTALLING TENSION STRUT ON LEFT AND RIGHT SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to INSTALLING THE REAR HOOD SEAL .
- Refer to INSTALLING THE ACOUSTIC COVER FOR THE ENGINE, FRONT .
- Refer to INSTALLING RESONATOR .
- Refer to INSTALLING ACOUSTIC COVER .
- Refer to FILLING THE HIGH-TEMPERATURE COOLING SYSTEM WITH THE VACUUM FILLING EQUIPMENT .
- Refer to VENTING THE HIGH-TEMPERATURE COOLANT SYSTEM .
- Refer to INSTALLING THE CENTER UNDERBODY PROTECTION .
- Refer to INSTALLING FRONT UNDERBODY PROTECTION .