Install the center console
NOTE:
To provide a better overview: Schematic diagram with partially hidden components.
- Install center console (1) from top rear and feed in the wiring harness.
- Check for correct cable routing under the center console (1).
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATIONS
| Center console to holder | ||
| M6x40 screw | Tightening torque | 4.6 Nm |
| Hexagon nut | Tightening torque | 4.6 Nm |
- Secure the wiring harness on the center console.
- Tighten the nuts (1) and bolts (2).
TIGHTENING TORQUE SPECIFICATIONS
| Center console to holder | ||
| M6x40 screw | Tightening torque | 4.6 Nm |
| Hexagon nut | Tightening torque | 4.6 Nm |
TIGHTENING TORQUE SPECIFICATIONS
| Center console lateral to bracket | ||
| screw | Tightening torque | 2.4 Nm |
Follow-up work
- Refer to INSTALLING THE REAR CENTER CONSOLE TRIM .
- Refer to INSTALLING THE FRONT STORAGE COMPARTMENT .
- Refer to INSTALLING THE CENTER CONSOLE TRIM .
- Refer to INSTALLING THE TRIM PANEL FOR THE PEDAL ASSEMBLY .
- Refer to INSTALLING RIGHT FOOTWELL TRIM .
- Refer to ACTIVATING ELECTRICAL SYSTEM .
- Refer to ACTIVATING THE 48 V ELECTRICAL SYSTEM .