Installing the tandem brake master cylinder
- Insert the tandem brake master cylinder (1) into the brake booster.
- Replace nuts (2)
.
Parts: Nuts
- Place and tighten nuts (2)
.TIGHTENING TORQUES SPECIFICATIONS
Tandem brake master cylinder in the brake booster M8
Replace nuts.Tightening torque 27 Nm - Fit brake lines (3)
and tighten.TIGHTENING TORQUES SPECIFICATIONS
Brake pipe screw connection/Union screws tightening torque 17 Nm
Follow-up work
- Refer to INSTALLING THE EXPANSION TANK .
- Refer to INSTALLING TENSION STRUT ON SHOCK TOWER .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to CONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to FLUSH AND VENTING THE REAR AXLE BRAKE CIRCUIT .
- Refer to FLUSH AND BLEEDING THE FRONT AXLE BRAKE CIRCUIT .
- Refer to DISCONNECTING THE BLEEDER UNIT FOR THE BRAKE FLUID .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .