Installing the bottom automatic air flap control

Connect the plug connection.
Feed in the bottom automatic air flap control (2).
Tighten down screws (1).

TIGHTENING TORQUE SPECIFICATIONS

Air flap control/Brake ventilation duct
Oval-head screw	tightening torque	4 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Installing the ACC sensor with holder

NOTE: The following step(s) must be performed if the specified component(s) is/are installed.

Attach the ACC sensor (3) with the holder and correctly position it.
Connect connectors (1) and lock.
Fasten the cable latches at the marked points.
Tighten the screws (2).

TIGHTENING TORQUE SPECIFICATIONS

Sensor bracket/ACC sensor/front radar sensor long range (FRSF)
Screw	Tightening torque	8 Nm

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting the ACC sensor

NOTE: TECHNICAL INFORMATION
Notes on the adjustment of the ACC sensor are a fundamental requirement for these repair instructions and must be complied with at all times.
For additional information see: ADJUSTING THE ACC SENSOR .

Adjust ACC sensor.

Follow-up work

Refer to INSTALLING BUMPER COVER, FRONT .
Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
Refer to INSTALLING FRONT ORNAMENTAL GRILLE .