Installing the ornamental grille on the front bumper cover on the side

• Slightly spread apart the detents (1) and insert the ultrasonic sensor (2).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip ornamental grille (2) into detents (3).
• Connect plug (1).

  Courtesy of BMW OF NORTH AMERICA, INC.

• Clip air duct (3) into detents (4).
• Clip vehicle wiring harness into clamp connections (1).
• Tighten screws (2).

Courtesy of BMW OF NORTH AMERICA, INC.

• Clip cover (1) of air inlet into detents (2).

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to INSTALLING FRONT TRIM STRIP .
• Refer to INSTALLING BUMPER COVER, FRONT .
• Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
• Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .