Removing the ornamental insert on the front bumper cover at side, left and right

NOTE: Description is for left component only. Procedure on the right side is identical.

Removing front side bumper cover inlay

Remove expanding rivet (1) .
Loosen inlay (2) from latch mechanisms (arrows) and remove.

G14930265

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work

Refer to INSTALLING THE TRIM ON THE FRONT BUMPER COVER .
Refer to INSTALLING THE ORNAMENTAL GRILLE FOR THE BUMPER COVER AT THE FRONT .
Refer to INSTALLING BUMPER COVER, FRONT .
Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
Refer to INSTALLING FRONT ORNAMENTAL GRILLE .
Refer to INSTALLING THE NUMBER PLATE BASEPLATE FOR THE LICENSE PLATE AT THE FRONT .