Install bumper cover, front

• Position bumper cover (1)  and engage in area of air flap control at top in mountings (2)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (4)  .
• Clip bumper cover (2)  into detents (3)  .
• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Connect connector (1)  in the right wheel well.
• Hook connector (1)  into holder (2)  .

  Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

• Tighten down screws (1)  .

Courtesy of BMW OF NORTH AMERICA, INC.

Follow-up work 

• Refer to PARTIALLY INSTALLING THE FRONT SECTIONS OF BOTH WHEEL ARCH COVERS AT THE FRONT .
• Refer to PARTIALLY INSTALLING THE LEFT AND RIGHT FRONT WHEEL ARCH TRIM .
• Refer to INSTALLING FRONT ORNAMENTAL GRILLE .