Installing the high pressure line between the high-pressure pump and the high-pressure rail for cylinders 1 to 3
- Guide in and install high pressure line (1) .
- Tighten the union nuts (arrows) with the special tool 0 495 280 (13 0 140) .
TIGHTENING TORQUES SPECIFICATION
| High pressure line between the rail and the high pressure pump | ||
|---|---|---|
| M14x1.5 | tightening torque | 33 Nm |
Follow-up work
- Refer to INSTALLING ALL IGNITION COILS .
- Refer to INSTALLING INTAKE FILTER HOUSING .
- Refer to INSTALLING THE STRUT BRACE .
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .
- Refer to ACTIVATING VEHICLE-SPECIFIC HIGH-VOLTAGE OR LOW-VOLTAGE VEHICLE ELECTRICAL SYSTEM .