Install tension strut on shock tower
NOTE:
Description is for left component only. Procedure on the right side is identical.
- Install the tension strut on the shock tower (3) .
- Replace the screw (1)
.
Parts: Screw
- Tighten the screws (1) .
TIGHTENING TORQUES SPECIFICATION
| Tension strut on firewall | ||
|---|---|---|
| M10x25 screw Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
- Replace the screw (2)
.
Parts: Screw
- Tighten the screws (2) .
TIGHTENING TORQUES SPECIFICATION
| Tension strut to shock tower | ||
|---|---|---|
| Torx bolt Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Refer to INSTALLING THE SEAL FOR THE HOOD GASKET LEFT AND RIGHT .
- Refer to INSTALLING WINDSHIELD PANEL COVER .
- Refer to INSTALLING LEFT AND RIGHT WIPER ARM .
- Refer to INSTALLING THE REAR RIGHT ENGINE COMPARTMENT COVER .
- Refer to INSTALLING THE COVER OF THE ENGINE COMPARTMENT ON THE REAR LEFT .