Installing fuel delivery line
- Slide the fuel supply line in the direction of the arrow into the snap fastener (2) and lock.
The fuel supply line must be audibly engage in the snap fastener (2).
- Secure the clamp (1).
- Tighten down screw (3).
TIGHTENING TORQUES SPECIFICATION
| Fuel line to cylinder head cover | ||
|---|---|---|
| 6x18 | Tightening torque | 7 Nm |
- Guide the fuel delivery line (2) in and install.
- Install rubber damper (3).
- Make sure the rubber damper (3) is fitted correct.
- Tighten the union nut (1) hand-tight.
- Tighten union nut (1).
TIGHTENING TORQUES SPECIFICATION
| Feed line to high pressure pump | ||
|---|---|---|
| M14X1.5 | Tightening torque | 26 Nm |
- Check fuel system for leak tightness.
Follow-up work
- Install the IGNITION COILS .
- Install rear ACOUSTIC COVER .
- Install the upper part COWL .
- Install ACOUSTIC COVER .
- Install windshield panel COVER .
- Install left and right WIPER ARM .
- Install the rear right engine compartment COVER .
- Install the rear left engine compartment COVER .
- Install the front hood rear SEAL .
- Reconnect all battery GROUND LEADS .