Remove oil-to-water heat exchanger
WARNING:
Hot surfaces.
Risk of burning!
Risk of burning!
- Perform all work only on components that have cooled down.
WARNING:
Hot fluids.
Risk of scalding!
Risk of scalding!
- Conduct all work in the vehicle wearing appropriate personal protective equipment only.
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Preliminary work
- Refer to REMOVING THE ACOUSTIC COVER .
- Refer to REMOVING RESONATOR .
- Refer to REMOVING THE OIL FILLER CAP
- Refer to RELEASING THE OIL FILTER COVER
- Refer to REMOVING THE FRONT UNDERBODY PROTECTION .
- Refer to REMOVING THE CENTER UNDERBODY PROTECTION .
- Refer to REMOVING COVER ON THE EXHAUST SYSTEM .
- Refer to REMOVING REAR UNDERBODY PROTECTION .
- Refer to RELEASING THE OIL DRAINING PLUG .
- Refer to TIGHTENING THE OIL DRAINING PLUG .
- Refer to REMOVING THE FRONT RIGHT LOWER WHEEL ARCH COVER .
- Refer to DRAINING THE COOLANT FOR THE HIGH-TEMPERATURE COOLANT CIRCUIT .
- Refer to CONNECTING THE COOLANT LINE TO THE RADIATOR .
- Refer to REMOVING TRANSMISSION OIL COOLER .
NOTE:
TECHNICAL INFORMATION
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
Collect and dispose of emerging fluids. Observe country-specific waste disposal regulations.
- Loosen the screws (1), (2), (3), (4), (5) and (6).NOTE: Loosen the lid on the full-flow oil filter so the oil flows back into the oil sump.
- Remove the oil coolant heat exchanger from the full-flow oil filter.