Install the rear top cross connection
- Feed in and position the rear top (3) cross connection.
- Tighten screws (2).
TIGHTENING TORQUES SPECIFICATION
| Rear cross connection at the top of the hood lock support | ||
| Hexagon screw M6x20 |
Tightening torque | 8 Nm |
- Replace screws (1).
Parts: screw
- Tighten the screws (1).
TIGHTENING TORQUE SPECIFICATION
| Rear top cross connection to wheel arch carrier support | ||
| M10x50 screw Replace screw. |
Joining torque | 56 Nm |
| Angle of rotation | 90° | |
Follow-up work
- Install the left and right hood gasket SEAL .
- Install the rear left and right engine compartment COVER PANEL .
- Install left and right FRONT-END STRUT .
- Install front CROSS CONNECTION .
- Install the top left and right engine compartment COVER .